Placement of 2nd Accessory Power Port?
Planning on adding a 2nd power source to front of bike which is a 2006 RT. This will be run to a switched fuse block. Looking for advice on good place to put second outlet. Current one I think is in stock location on left side. Looks like 2nd one may fit well just up from that one on flat area of fairing. Pros/cons?
1. Convenient spot you can reach.
2. Location which you can drill for flush mount or bolts.
3. Nothing behind it - leaving room for socket and wires, etc.
Otherwise - where you want it.
When Old Smokey had about 250,000 miles I put one in one of the sidecovers. After I drilled the hole I told Voni that I had ruined the stock appearance.
Paul Glaves - "Big Bend", Texas U.S.A
"The greatest challenge to any thinker is stating the problem in a way that will allow a solution." - Bertrand Russell
The powerlet low outlet makes a good choice because the kit comes pre-wired with a disconnect. That way you can pull the disconnect to remove the panel its in.
Sometimes folks forget to plan ahead for normal service when wiring accessories- which end up inteferring with service.