I have the monitor system mounted and initialized. Here is a shot of my mounting on an R1150RT:
I rode it less than a quarter mile and it picked up my front and rear sensors. I had to set it to PSI rather than BAR, set my low and high pressure trigger values and the time. I stumbled through the settings step but finally got it. The directions are a bit cryptic. You can notice the outside temp display on the lower right. I need to change that to F. There is another display that shows only tire temperature but I haven't gotten there yet. The white dot top center is the LED warning light. I managed to light it up trying to set the pressure limit the first try.
The dashes show up where the pressures are, since the wheels were not turning when I took the picture it doesn't show. It picks it very quickly though.
Well that's my very short experience so far. I think I will like this and will post back periodically.
Thanks for the interest,