Hello , I have just rebuilt the Bing 94 Carbs on my 1980 R100RT , I changed the cables also and the bike starts and runs but has a noticeable vibration.
so now I want to adjust the synch. of the carburetors. Reading the various manuals and as I understand it my basic set up is with the idle stops screwed in one turn from just touching the lever and the idle mix screw one turn out from a gentle seating. Then the cables , when attached should have 1/2 mm of loose play at the carbs. this being both the throttle and the enrichener. I have two single throttle cables no 'Tee'.
and now the question is which method of synchronizing shall I use?
I have read snobum and feel that I should buy a vacuum synchronizer but which one? there are a couple in the Bing catalogue 'Carb mate' and 'Synchromate II' I am sure there are many more any one have any advice here for the amateur, much appreciated. Thank you Heed