Probably not a difficult job but am erring on side of caution . . .
New switches/wires on the way from Hucky's - originals are not in good shape - broken contacts, brittle wires - Also ordered a new wire terminal strip as part of the existing block must've gotten hot at some point in the bike's history and melted on one end.
Here's my questions:
Did I read correctly that I need to rivet the new block through the bottom of the headlight?
Thinking if I just take my time & take picture where existing wires are placed, this should go smoothly.
Did see a post yesterday where Lew provides a large schematic - mine has fuses.
Will take it slow. Any words of wisdom appreciated.