Quote Originally Posted by Paul_F View Post
I need to remove the rubber boot to get to the clip. Once the new bulb is locked into place, for me, it is easier to run the connector through the boot, make the connection to the bulb's three prongs and then pull the boot over the outside circumference. First attempt (putting the rubber boot on before attaching the connector) took forever and subsequent bulb changes run about 5 minutes.
I just discovered the source of my confusion; nothing like actually doing the job. I thought the rubber boot over the connector was a separate piece from the large round cover, which I thought was plastic. Turns out it is just one big rubber boot. Thanks for your help...