Results 1 to 4 of 4

Thread: 05-up R1200RT-P seat mounting

Hybrid View

  1. #1
    Registered User roadstar's Avatar
    Join Date
    Dec 2012
    Location
    Lancaster PA
    Posts
    40

    05-up R1200RT-P seat mounting

    I purchased the fill in seat section off an 06 RT-P & i`m trying to figure out where the back mount slide pin bolts too. I`m fitting this onto my 2010 R1200RT non P & noticed also that the shock adjuster knob seems to be in the way also. Does anyone have a good pic of the mounting of this setup . I`m going this route , so i can run a fuel cell where the back seat would go & the filler is just perfect.
    MOA #165182
    IBA #47424
    2010 R1200RT
    1994 K1100LT (sold)

  2. #2
    Registered User roadstar's Avatar
    Join Date
    Dec 2012
    Location
    Lancaster PA
    Posts
    40
    I also noticed on the bottom front of the fill in section , that it has a spring clip setup that slips onto something below the riders seat (need pics of that also. This way i can order the parts from Bobs BMW.

    Thanks
    MOA #165182
    IBA #47424
    2010 R1200RT
    1994 K1100LT (sold)

  3. #3
    Registered User
    Join Date
    Aug 2012
    Location
    Blaine, WA
    Posts
    12
    Quote Originally Posted by roadstar View Post
    I purchased the fill in seat section off an 06 RT-P & i`m trying to figure out where the back mount slide pin bolts too. I`m fitting this onto my 2010 R1200RT non P & noticed also that the shock adjuster knob seems to be in the way also. Does anyone have a good pic of the mounting of this setup . I`m going this route , so i can run a fuel cell where the back seat would go & the filler is just perfect.
    Hi, I have an 06 RTP but am a little vague on exactly what you are looking for. The P uses a the normal front seat then has two blocks (filler pieces at the rear of the seat) that slide sideways to gain access for seat removal and under seat service. Each of these two seat block halves slide together and hit you in the tail-bone while sitting on the seat.........are these blocks what you are addressing??
    Bob

  4. #4
    Registered User roadstar's Avatar
    Join Date
    Dec 2012
    Location
    Lancaster PA
    Posts
    40
    Quote Originally Posted by BOBBBAY View Post
    Hi, I have an 06 RTP but am a little vague on exactly what you are looking for. The P uses a the normal front seat then has two blocks (filler pieces at the rear of the seat) that slide sideways to gain access for seat removal and under seat service. Each of these two seat block halves slide together and hit you in the tail-bone while sitting on the seat.........are these blocks what you are addressing??
    Bob
    Thats for the reply , one member from another forum sent me a bunch of pics that were very helpfull & in the spring (after i recoupe) & will install them (modified a little) with the cell i`m picking up.
    MOA #165182
    IBA #47424
    2010 R1200RT
    1994 K1100LT (sold)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •