Results 1 to 10 of 10

Thread: Crankshaft moved forward

Hybrid View

  1. #1
    Georgia SUNRIDER711's Avatar
    Join Date
    Mar 2005
    Location
    Lubbock, TX
    Posts
    15

    Crankshaft moved forward

    I was trying to put in a clutch on a 1980 R100RT, the crankshaft moved forward.
    Is there any hope for this machine?

  2. #2
    Administrator 20774's Avatar
    Join Date
    Sep 2005
    Location
    San Antonio, TX
    Posts
    13,196
    Yes, but it's going to be a pain in the butt. This is going to require some engine disassembly. Read what Snowbum has to say:

    http://bmwmotorcycletech.info/flywhe...valwarning.htm

    You might be able to see if thrust washer as moved...if not then, you might have dodged a bullet. But you have to at least investigate.
    Kurt -- Forum Administrator ---> Resources and Links Thread <---
    '78 R100/7 & '69 R69S & '52 R25/2
    mine-ineye-deatheah-pielayah-jooa-kalayus. oolah-minane-hay-meeriah-kal-oyus-algay-a-thaykin', buddy!

  3. #3
    Monza Blue 1974 R90/6
    Join Date
    Dec 2006
    Location
    Delaware
    Posts
    431
    How did the crank move forward? You had the flywheel off?

    Barron

  4. #4
    Georgia SUNRIDER711's Avatar
    Join Date
    Mar 2005
    Location
    Lubbock, TX
    Posts
    15
    Flywheel was off,,,, didn't block the crank.
    I previously replaced the clutch on my 1979 R100RT twice with no problem.

  5. #5
    Administrator 20774's Avatar
    Join Date
    Sep 2005
    Location
    San Antonio, TX
    Posts
    13,196
    Ooops...third time wasn't the charm... Sorry...
    Kurt -- Forum Administrator ---> Resources and Links Thread <---
    '78 R100/7 & '69 R69S & '52 R25/2
    mine-ineye-deatheah-pielayah-jooa-kalayus. oolah-minane-hay-meeriah-kal-oyus-algay-a-thaykin', buddy!

  6. #6
    Fixes Gauges tvrla's Avatar
    Join Date
    Oct 2004
    Location
    Portland, Oregon
    Posts
    127
    Good thing you noticed and didn't just try to bolt it back up and cinch it down!!!

    It may seem like a lot of extra trouble at this point but it could be much MUCH worse! I've also done a clutch without blocking the crank - must have been fifteen years ago before I got smart. Was lucky that time like you were the other the fast two.

  7. #7
    Rally Rat
    Join Date
    Sep 2007
    Posts
    1,248
    Youi may not be in trouble. The thrust washers on either side of the crankcase usually resist falling out of position. Carefully push the crank back, then put the flywheel on. If it seats, you're probably OK. If not, you'll have to pull the right cylinder and "fish" the washer back into place.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •