Off looking at yet another potential 4th Gen 4Runner I noticed a Harbor Freight tool store across the way. I stopped in and was handed a load of coupons by someone leaving, including ones for $10 torque wrench and $10 lever grease gun. Walked out with those two and an assortment of other things I sort of need
I stopped and got a tube of synthetic grease and this morning attacked the side and center stand. Well, it took all of 30 seconds. There are three zerk fittings I could see, one on the side stand and two for the center. Couple pumps on each, just until the grease starts squeeging out. It had not been done in a while, certainly not since I have owned it, and is easily overlooked. The early k bikes did not have zerks so check yours before proceeding.