Results 1 to 13 of 13

Thread: A how to Build your own Rear Mud flap

Threaded View

  1. #1
    PRAY BEFORE RIDING roadcrave's Avatar
    Join Date
    Jul 2004
    Location
    ninemilefalls,wash
    Posts
    313

    A how to Build your own Rear Mud flap

    I was disgusted with all the gravel - tar and mud the rear tire pics up here in the NW so I did some research and came up with this step by step to add protection to your rear swing arm/shock/dog leg from getting trashed every time you ride. Here is what you need
    1. urethane rubber Ebay / POLYURETHANE/URETHANE SHEET 1/8" X 9 3/4" X 14" 80/85 Black Part#102
    2. rivots aluminum 1/8 x 3/16
    3. sheet metal sheers
    4. rivot gun
    5. washers

    Remove your factory rear mud gaurd, place on the table and scribe as wide as you wish I went 1/2 wider than the wheel and 1 inch lower than the center stand in the up position, then cut and pre drill your holes, .\see pic
    Pop rivot the gaurd to the foward part of the factory gaurd using backup washers
    Attached Images Attached Images

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •