Results 1 to 15 of 46

Thread: Pictorial--2002 1150RT Spline lube

Hybrid View

  1. #1
    Registered User Olsensan's Avatar
    Join Date
    May 2008
    Location
    Adirondaks and LI,NY
    Posts
    461

    Pictorial--2002 1150RT Spline lube

    I've just finished lubing the splines on my 1150RT and I'll post 5 or so pics per day illustrating the same to help anyone out there wanting to pursue this endeavor. I'm assuming that you have already removed the tupperware from the bike and secured the front wheel to your centerstand. Also document the wire runs from every angle if you can because you will want to route everything as it was with the exception of the shift indicator wire and connector. You'll hear more on that below. There are other procedures I used by Awagnon, a member here that provides a great procedural and Grant at ADVRIDER who provides another pictorial on his GS. Powerman also provides a written procedural which I used, all found here:

    Awagnon's procedural:
    http://dl.dropbox.com/u/35468239/Spl...%2026%2011.doc

    Grants pictorial:
    http://advrider.com/forums/showthrea...ighlight=Grant

    Powermans procedural:
    http://kueglers.org/Powermans%20Spli...0Procedure.pdf

    Also, this link may assist you in disassembling the gear shift indicator connector so that it will pass easily through the tight space under the battery tray. This has been referred to as the most difficult and time consuming task of removing the transmission. Go to this link, and refer to page 10.
    http://www.rbracing-rsr.com/download...connectors.pdf
    Attached Images Attached Images
    Last edited by OLSENSAN; 03-04-2012 at 02:35 AM.

  2. #2
    Registered User Olsensan's Avatar
    Join Date
    May 2008
    Location
    Adirondaks and LI,NY
    Posts
    461
    Documenting wiring etc.
    Attached Images Attached Images

  3. #3
    Registered User Olsensan's Avatar
    Join Date
    May 2008
    Location
    Adirondaks and LI,NY
    Posts
    461
    Day one
    Attached Images Attached Images

  4. #4
    Registered User Olsensan's Avatar
    Join Date
    May 2008
    Location
    Adirondaks and LI,NY
    Posts
    461
    Separating the radio from the tank up forward.
    Attached Images Attached Images

  5. #5
    Registered User Olsensan's Avatar
    Join Date
    May 2008
    Location
    Adirondaks and LI,NY
    Posts
    461
    Removing the rear radio securing hardware.
    Attached Images Attached Images

  6. #6
    Registered User Olsensan's Avatar
    Join Date
    May 2008
    Location
    Adirondaks and LI,NY
    Posts
    461
    Don't forget the little nub back here that holds the radio in the box.
    Attached Images Attached Images

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •