-
Honey Badger
Lube the o-ring slightly with gear oil as that will facilitate re-insertion – do not pinch or cut the o-ring as you will develop a leak.
Push in firmly and evenly - you have to ensure proper seating and fit of the o-ring.
Once done tighten it with a T-25, the specification is 4Nm but i do it hand tight.
Last edited by Semper_Fi; 04-19-2009 at 02:51 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
