Results 1 to 5 of 5

Thread: Wierd ABS fault

  1. #1
    K1200RS spikethebike's Avatar
    Join Date
    Apr 2004
    Location
    Portland, OR
    Posts
    13

    Wierd ABS fault

    I have been getting ABS faults when I hit bumps with my K12RS.
    When I stop and switch the ignition off then on again, it clears.
    This caused me a bit of excitment at one point today as I got a little air at the same time I needed to scrub off a bit of speed- the front locked and started to go sideways, butt I caught it before it got too interesting.
    Could this be caused by the sensor gap being a bit off?
    Thanks a lot for any suggestions!

    Spike

  2. #2
    Focused kbasa's Avatar
    Join Date
    Mar 2003
    Location
    Marin By God County, California
    Posts
    11,639
    I'd try that, Spike, but I'd look and make sure the sensor is mounted securely too.
    Dave Swider
    Marin County, CA

    Some bikes. Some with motors, some without.

  3. #3
    K1200RS spikethebike's Avatar
    Join Date
    Apr 2004
    Location
    Portland, OR
    Posts
    13
    Righto, I'll check everything in the general area. I know this is not supposed to happen as I have hammered my previous K12 over Mattole road at injudicious speeds without a problem!

  4. #4
    YO YO! LICK MY BRICK's Avatar
    Join Date
    Jun 2003
    Location
    NEW YORK CITY
    Posts
    78

    Talking

    A Little air?

  5. #5
    Focused kbasa's Avatar
    Join Date
    Mar 2003
    Location
    Marin By God County, California
    Posts
    11,639
    Things are different in PDX, especially if you're Spike.
    Dave Swider
    Marin County, CA

    Some bikes. Some with motors, some without.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •