I got a performance "warning" back in July of '05 from a CHP officer at the very spot your RT's parked. I was headed to Breckenridge at the time.
Did you see many CHP dudes during your ride??
'99 R1100R & '02 RT
'06 K12s bumblebee
Steve, once again, thoroughly enjoyed the sights and sounds of your report. But, I have to ask, at 10,000 feet, 30 degrees, and 40mph winds, is there so much salt/sand on the road that ice isn't an issue??? The video really shows how the sun can really mask what the road surface is like. Salt residue and ice can look identical.
Thank you for sharing the video. I want to record like that. What kind of camera equipment do you use and how is it mounted and wired? Also what editing software do you use? Thanks again.
okay, me confused too. never seen salt used (maybe just not here n front Range territory), but the MagCl is fairly common.
Ride Safe, Ride Lots
I do beleive your right!
To my knowledge the front range never used the salt, but the high country (the roads with increasing elevation) CDOT were not past throwing a bit on the roads to keep the the touristos from sliding off on the way to spend money at the ski areas!
Any editing software will do, even the freely available Microsoft Movie Maker, but for this recording used Sony Vegas.
Stephen Burns - 2007 R1200GS
BMW MOA Lifetime Member
Steve your RT and mine are quite similar, even the black lowers. I'm interested in what equipment you used to record the video; camera, mounts, etc. I notice you had the windscreen in the full "up" position. Was this due to the weather or does your camera require that?
Thanks man, nice ride!
Wez... This vid was from a digital camera (sony Cybershot) movie mode test where I removed the GPS from its Techmount mount (using the empty hole near the clutch reservoir) and pointed it through the screen. Challenge I had was if I extended the mount arm up high the edge of the screen would have been right in the middle of the recording! Thus, I angled the mount towards the inside of the screen (thus lowering it), and the cam then captured a portion of the screen support bracket.
In the brisk wind, yes, I did have the screen up some, but it wasn't up all the way.