Search:

Type: Posts; User: Fourcats; Keyword(s):

Page 1 of 3 1 2 3

Search: Search took 0.05 seconds.

  1. Replies
    11
    Views
    738

    Looks like its off a Harley....:lurk

    Looks like its off a Harley....:lurk
  2. Practice your figure 8s {slow speed manuvering},...

    Practice your figure 8s {slow speed manuvering}, "eyes up" looking though the turns.
  3. Replies
    37
    Views
    2,279

    I have mostly just accepted the term, believing...

    I have mostly just accepted the term, believing that the forces in question do a good job of getting me around...The diagram is great, simple and confirms my beliefs. :thumb
  4. Replies
    6
    Views
    627

    Nice fix...:thumb

    Nice fix...:thumb
  5. Replies
    10
    Views
    1,261

    tape...

    Yikes! Relative speed, relative distance and direction...just where were you going?? {maybe the tape just "looks bad" :stick}

    ...how many "mistakes" do you make, per ride?
  6. Replies
    37
    Views
    3,134

    :laugh THAT is funny!

    :laugh THAT is funny!
  7. Replies
    18
    Views
    1,326

    Pick a direction and GO for six days...see if you...

    Pick a direction and GO for six days...see if you make it back on time.
  8. It happened about a block away from the dealer...

    It happened about a block away from the dealer who had "adjusted" the bearings, guess it was 35mph. Made it real easy to snap a Uturn back to the shop...
    That is the only issue I've had with the...
  9. The bike doesn't dive right or left {from the...

    The bike doesn't dive right or left {from the adjustment being tight}.
  10. Thread: Yosemite

    by Fourcats
    Replies
    18
    Views
    2,291

    Try the Tuolumne Lodge for a place to stay & eat....

    Try the Tuolumne Lodge for a place to stay & eat.

    When you go into the park ask the Ranger to remind the next ten vehicles "not to tailgate"...
  11. Replies
    16
    Views
    3,045

    This is my favorite shot, "the least photographed...

    This is my favorite shot, "the least photographed tree". Having seen the West side up to the "Weeping Wall" we took Hwy2 to the East entrance and back to Kalispell, good road.
    The following day...
  12. Replies
    9
    Views
    991

    I remember taking the horn apart, cleaning it,...

    I remember taking the horn apart, cleaning it, making a gasket from a box of Corn Flakes, then tuning it with the screw on the back...
  13. Thread: Clutch noise

    by Fourcats
    Replies
    9
    Views
    1,017

    Don't do THAT...Smooth works just fine. :thumb

    Don't do THAT...Smooth works just fine. :thumb
  14. Thread: gas cap

    by Fourcats
    Replies
    11
    Views
    966

    Drill close enough to the center so you don't hit...

    Drill close enough to the center so you don't hit the tank.
  15. Thread: gas cap

    by Fourcats
    Replies
    11
    Views
    966

    I drilled the cap {thru the BMW logo} with a 3/16...

    I drilled the cap {thru the BMW logo} with a 3/16 bit. Then, with the bit in the cap, it can be turned and removed.
  16. Replies
    8
    Views
    1,404

    Clean the seat good, inspect it visually so you...

    Clean the seat good, inspect it visually so you know what it looks like. Place a clean steel ball bearing {of the appropiate size} in the seat. Using a pin punch, set the ball with a single tap of a...
  17. Thread: Float level?

    by Fourcats
    Replies
    22
    Views
    1,233

    There are "two" engines that need to be matched...

    There are "two" engines that need to be matched up {balanced} as best you can.
    I made up a set of tubes {one for each carb} that Tee'd into a single vacuum gage. It produced a bouncing...
  18. Replies
    25
    Views
    2,362

    ...service light

    So what is the service light for {other than a reminder}? Can you pull a fuse, disconnect the battery to turn it off?
  19. Thread: track school

    by Fourcats
    Replies
    33
    Views
    2,966

    We're waiting...:whistle So how waz it, did...

    We're waiting...:whistle

    So how waz it, did you get passed alot?
  20. Replies
    6
    Views
    788

    /5 hub

    Take a center punch and "dimple" the inside of the hub to snug up the fit.
  21. Replies
    13
    Views
    4,612

    Bleeding/flushing the system with alcohol prior...

    Bleeding/flushing the system with alcohol prior to disassembly will save some of the mess. Its cheaper and cleans up easier than DOT4. :lurk
  22. Thread: What to buy?

    by Fourcats
    Replies
    45
    Views
    3,479

    There is a nice blue RT on Ebay...16hrs left.

    There is a nice blue RT on Ebay...16hrs left.
  23. Thread: What to buy?

    by Fourcats
    Replies
    45
    Views
    3,479

    What to buy...

    Buy a seat {or two:hug} in a MSF course... :thumb
  24. Replies
    37
    Views
    3,189

    flats...

    Got the "wobble" recently, almost exactly 100 miles to {or from} a shop and about 7 miles from a phone. Called AAA and got the bike to Lewiston, ID. where I learned they "don't fix flats"...they can...
  25. Thread: track school

    by Fourcats
    Replies
    33
    Views
    2,966

    September is real close....Have you been reading?...

    September is real close....Have you been reading? :stick
Results 1 to 25 of 51
Page 1 of 3 1 2 3