Search:

Type: Posts; User: pszyjka; Keyword(s):

Search: Search took 0.05 seconds.

  1. Replies
    18
    Views
    1,210

    valve cover nut

    Thanks again for the info. This forum is an endless wealth of knowledge.
  2. Replies
    18
    Views
    1,210

    Thread pitch

    Does anyone know the thread pitch to the stud. Or, could someone post a link to the helicoil product mentioned for this M8x70 stud, thanks.
  3. Replies
    10
    Views
    823

    They seem to be fine. I thought initially the...

    They seem to be fine. I thought initially the problem was a vacuum leak.
  4. Replies
    10
    Views
    823

    In what way can I make sure TDC is achieved...

    In what way can I make sure TDC is achieved without relying on "OT" on the flywheel?
  5. Replies
    10
    Views
    823

    1976 R90/6 Valve adjustment issues

    I seem to be having problems "keeping" my valve clearance adjusted properly. I'm able to set the clearance initially but after about 20 miles the bike begins to progressively get more chuggy and the...
  6. Replies
    6
    Views
    538

    Haynes manual.

    Haynes manual.
  7. Replies
    6
    Views
    538

    R90/6 needle clip posiiton.

    What is the needle clip position for a '76 R90/6. the Bing manual says #2, but other sources say #1. Thanks.
  8. Tall block on chinese made points.

    What do you think the success rates are on filing the block down on this Chinese made item are? Little by little perhaps? This tall block theory seems to be the one, I for sure have the Chinese made...
  9. Thanks, great help.

    These are all a great help. Please excuse my ignorance but what does "+4" mean exactly?
  10. Timing and points problem 1976 R90/6 not starting.

    I recently replaced my points on my r90/6 and can't seem to advance the timing enough to get the bike to fire up. While using the alligator clip to light bulb method to set the timing initially I can...
  11. Replies
    3
    Views
    678

    I did not disconnect the battery first, prob a...

    I did not disconnect the battery first, prob a bad decision? Ive done it before without a problem. I'll check the junction and the fuze wire.
  12. Replies
    3
    Views
    678

    Starting problem r90/6, all my fault?

    After timing my '76 R90/6 using the light bulb to alligator clip method my bike won't start. Before I even finished timing the bike, the lightbulb method stopped working no power to the bulb. In fact...
  13. Replies
    3
    Views
    976

    Saddle tear fix?

    I am repairing tears in my r90/6 saddle and I'm looking for suggestions on what glue/vinyl repair to use. I took the cover off and plan to patch form the back, then reinstall. What do you think?
  14. Replies
    1
    Views
    573

    R90/6 basic carb throttle adj?

    I just finished rebuilding a 1976 R90/6 and need some information on basic adjustments on the idle mix screw, and throttle stop screw. Any Ideas. I can get it to ride but it has a drop of power when...
Results 1 to 14 of 14