Search:

Type: Posts; User: bmwroadsterca; Keyword(s):

Page 1 of 2 1 2

Search: Search took 0.06 seconds.

  1. Replies
    18
    Views
    2,667

    They all do that

    Literally all new F800 bikes turn the rear brake fluid black. Its colour from the hose. After a brake flush or two it stays clear. Don't worry about it.

    Some folks cut and bend a coat hanger to...
  2. Bmw is working on 300 cc model for india

    Read about it here.
    http://canadamotoguide.com/2014/04/24/reports-bmw-working-300-cc-model-india/
    mike
  3. If you search F800/650GS fora for hits on the...

    If you search F800/650GS fora for hits on the F800S/ST clutch cable I am sure you will find what you are looking for.
  4. Replies
    16
    Views
    1,265

    Sitting on the center stand the bike is quite...

    Sitting on the center stand the bike is quite close to balance fore and aft. As a consequence the load on whatever you put under the engine to keep the front end up is rather modest. I use a floor...
  5. Odd

    See:

    http://healthycanadians.gc.ca/recall-alert-rappel-avis/tc/2013/34167r-eng.php

    There was no F700GS in 2011 yet it is listed as an affected model.

    mike
  6. Replies
    14
    Views
    1,383

    Tire Fix

    I just picked up two of these (two bikes to trailer). I knew as soon as I read about them that they would work better than any conventional tie-downs. Pricey but I figure that it's worth the peace of...
  7. Thread: Stators

    by bmwroadsterca
    Replies
    34
    Views
    4,659

    Old vs new rotor

    See post #563 here:
    http://www.advrider.com/forums/showthread.php?t=706033&highlight=stator&page=38

    mike
  8. Standard Center Stand is fine

    My wife's low F650GS has the OEM stand. The bike goes up easy.

    mike
  9. Replies
    13
    Views
    1,277

    Also of interest

    Hope this works.....
    ...
  10. Replies
    13
    Views
    1,277

    Cmg

    An overdue intorduction to CMG is in order!

    Eons ago, when dinosaurs roamed Alberta, Canadian Motorcycle Guide was a print publication catering to Canuckian moto enthusiasts.

    Fast forward to...
  11. Replies
    13
    Views
    1,277

    Canadian Pricing

    The CMG site reported that BMW had released pricing.

    "Canadian pricing has been announced for BMWÔÇÖs 2013 F700GS and F800GS models.
    The F700GS will retail for $10,650 up here in the Great...
  12. Replies
    3
    Views
    708

    Relax

    Don't obsess over the BMW instructions. The change in oil volume between a hot engine and an engine hot enough to make the fan run is too small to be significant. Take a the bike for a good spin,...
  13. Replies
    7
    Views
    900

    Stock centerstand works fine

    My wife's lowered F650GS has the stock height centerstand on it and it works fine.

    mike
  14. Replies
    13
    Views
    1,219

    Parking light

    I have used the "CAN-BUS (sic) electrical connector" on two F650GS (twin) bikes to activate a relay for auxiliary lights and it does work well.

    mike
  15. Replies
    13
    Views
    1,219

    Don't use tail light lead

    On the F800GS/F650GS a LED tailight is used. The same LEDs are used for the running and tail light. The brightness is varied by changing from a pulsed mode (too fast for the eye to see the flashing...
  16. Replies
    16
    Views
    12,743

    BMW Canada Service Schedule

    For the F800GS see:

    http://www.bmw-motorrad.ca/pdfs/maintenance/F800GS.pdf

    Hunt around the site and several other models can be found.

    I edited the form a bit use it as a checklist and...
  17. Replies
    14
    Views
    1,364

    Cree

    See
    http://www.cree.com/

    mike
  18. Replies
    11
    Views
    2,079

    Corrupted volatile memory?

    I saved the following text from a posting someone did somewhere in a forum. Apologies to the author for not having a proper citation but I think it advances the discussion here.

    mike

    "My warm...
  19. Replies
    8
    Views
    803

    No start

    I had a similar issue a few weeks back. Checked everything and all was fine. In the end I opened the throttle wide open and cranked it over for a while and away it went. Has been perfectly normal...
  20. Replies
    12
    Views
    2,567

    Not for the faint of heart

    When I bought my 1995 R1100R in 2000 the dealer had installed updated head gaskets and a re-torque was called for at 1000kms. As I lived quite a distance from the dealer I chose to do it myself...
  21. Replies
    3
    Views
    1,419

    Rear Axle Torque Spec

    Spec says 100 Nm.

    Enjoy!
  22. Replies
    12
    Views
    2,746

    Or do this with the BMW toolkit socket

    See attachment
  23. Why a bicycle computer?

    In my case I wanted a clock since my bike did not come with the optional R1100R clock. For very little money one can get a bicycle computer that has a clock and a whole host of other neat features...
  24. Sigma Install

    Here is the install of a Sigma Sport on my R1100R. I fabricated the aluminum bracket for the pickup. The magnet is held to the disc by a plastic bolt (less weight - no rust) and a cable clamp. Check...
  25. Replies
    7
    Views
    2,237

    Mounting details please

    Indeed a great photo. Would you please add some photos showing the details of the mounting hardware? I need to replace the stock windshield on my wife's K75 and this is a prime candidate.

    Thanks...
Results 1 to 25 of 36
Page 1 of 2 1 2