Search:

Type: Posts; User: 44817; Keyword(s):

Page 1 of 2 1 2

Search: Search took 0.07 seconds.

  1. Replies
    4
    Views
    476

    I believe if you look closely, you'll see the...

    I believe if you look closely, you'll see the parking bulb on when the headlight is on too. Keeps the filament from breaking?
  2. Replies
    14
    Views
    1,133

    I believe your bike is covered in BMW's manual 01...

    I believe your bike is covered in BMW's manual 01 51 9 798 461. Max has them.
  3. Replies
    30
    Views
    1,624

    The OP says the gen light is good, but he also...

    The OP says the gen light is good, but he also says it doesn't come on with the key turned on or with the engine idling.
  4. Replies
    18
    Views
    1,206

    I always take the front wheel off to get the rear...

    I always take the front wheel off to get the rear wheel out. Works every time. And saves time. I set the front end down on the fork tubes rather than hold up the rear end.
  5. Thread: Parts Question

    by 44817
    Replies
    4
    Views
    535

    Item 13 on Card 31-0315, 31 42 1 231 483, is...

    Item 13 on Card 31-0315, 31 42 1 231 483, is indeed the o ring that goes in the lower leg on the ATE brake models up to 9/80 with the eccentric adjuster. Item 2 on Card 34-0604, 34 11 1 231 469, is...
  6. I'm not near Chicago, but I personally like have...

    I'm not near Chicago, but I personally like have the pinstripes exposed to the elements. I want my legs to wear off the stripes over time. I would suggest going to a big car show or a hot rod shop...
  7. Replies
    12
    Views
    474

    I've always wondered why aftermarket carbs are...

    I've always wondered why aftermarket carbs are better than the Bings. I liked the accelerator pumps on the Dellortos, but the Mikunis don't have that, right?
  8. I always use non detergent for break in. Less...

    I always use non detergent for break in. Less additives keep the cylinder walls from glazing. Drain it as soon as you get a few hours on it and are happy that its not using oil.
  9. Replies
    5
    Views
    666

    Sometimes they just give up. New spring is...

    Sometimes they just give up. New spring is cheap.
    Not trying to criticize, and maybe thats how it was when you got it, but please don't use split lock washers anywhere on our beloved BMWs.
  10. Replies
    11
    Views
    629

    I always assumed those extra holes were for a...

    I always assumed those extra holes were for a sidecar.
  11. Replies
    15
    Views
    1,425

    Check the bulb anyway. They can get a little...

    Check the bulb anyway. They can get a little corroded in their socket.
  12. 1. Nice, but not critical 2. Orings and Ultra...

    1. Nice, but not critical
    2. Orings and Ultra Grey
    3. Replace
    4. Check the end gaps, you may be surprised. I missed how many miles this engine has on it, but I never topped my 75/7 until 96,000...
  13. Replies
    9
    Views
    784

    Just loosen the valve adjustment screws all the...

    Just loosen the valve adjustment screws all the way so the valves are closed at bottom dead center. Probably easier to tell if air leaks out the exhaust if you take the mufflers off. Likewise with...
  14. Replies
    5
    Views
    647

    I'd just run it. Probably some over zealous PO...

    I'd just run it. Probably some over zealous PO put it on there "just in case". My thought is if it was really leaking, that glob of silicone wouldn't change anything. Besides, it doesn't look like...
  15. Replies
    7
    Views
    711

    Something to keep in mind when fueling: Nearly...

    Something to keep in mind when fueling: Nearly every gas station's tanks are underground, so when it goes in the tank, its 60 or 70 degrees. When you put it in a steel tank that sits right above a...
  16. Replies
    18
    Views
    1,339

    Water froze in the float bowl, thats how it split.

    Water froze in the float bowl, thats how it split.
  17. Replies
    18
    Views
    949

    Mine is a 72, and as far as I know, that system...

    Mine is a 72, and as far as I know, that system was used on all the /5 levers. If you were working on a /6 and up, the post from Kurt above would work.
  18. Replies
    18
    Views
    949

    You have to push the cable into the lever the...

    You have to push the cable into the lever the opposite way as when you pull on the clutch cable. Once its far enough into the internal recess of the lever, the barrel will slip out of the bottom and...
  19. Replies
    4
    Views
    779

    Been a while since I've had Dellortos, but in...

    Been a while since I've had Dellortos, but in general, any carb that runs better with the air screws all the way in is because a vacuum leak is replacing the controlled vacuum leak that goes through...
  20. Replies
    15
    Views
    1,067

    The squeaky hinge noise is probably the crankcase...

    The squeaky hinge noise is probably the crankcase breather. You can take the breather housing off and verify, its the piece the breather hose attaches to at the forward end, next to the starter.
  21. Bob's BMW sold me the Ultra Grey as a replacement...

    Bob's BMW sold me the Ultra Grey as a replacement for DreiBond for my /7 cylinder resealing last weekend.
  22. Replies
    4
    Views
    584

    Maybe I'm missing the point, but the maintenance...

    Maybe I'm missing the point, but the maintenance you're talking about doesn't require engine removal. Very little does, except powder coating the frame. Anyway, the easiest way I've found is to...
  23. Replies
    7
    Views
    716

    This is a good reason to never use a pressure...

    This is a good reason to never use a pressure washer (even if you didn't)
  24. Replies
    17
    Views
    1,772

    That part number is listed for a 75/5. Look at...

    That part number is listed for a 75/5. Look at diagram 63_0341, item 3. Something else to consider is to buy the original /5 reflector, 63 12 1 351 652 for about half the price, then buy an H4 bulb...
  25. Replies
    18
    Views
    1,621

    Have you checked the timing on both cylinders? ...

    Have you checked the timing on both cylinders? If I remember, the Dyna 3 uses two different pickups, one for each cylinder. So you can't just rely on timing the left and assuming the right is...
Results 1 to 25 of 32
Page 1 of 2 1 2