Search:

Type: Posts; User: jupiteral; Keyword(s):

Search: Search took 0.06 seconds.

  1. Replies
    12
    Views
    1,077

    ONLY 86 PSI- sounds a little low ?!

    ONLY 86 PSI- sounds a little low ?!
  2. Replies
    3
    Views
    544

    Compression PSI on an '81R00

    Having a valve job done. Does anyone know how much compression P.S.I. an R100 is supposed to put out ? Thanx
  3. Replies
    12
    Views
    1,077

    Did a compression test & the dead cylinder shows...

    Did a compression test & the dead cylinder shows only 62 PSI or so.. took the head off & sent it out for a valve job...I know, I know- you should do both cylinders... thanks to all of you airheads...
  4. Replies
    12
    Views
    1,077

    '81 R100 running on 1 cylinder

    My airhead is only running on 1 cylinder. I pulled the carb & cleaned it. It's getting plenty of fuel. Next I pulled the spark plug & held it against the engine block while turning it over to check...
  5. will a front end of an '87 R80 fit an '81 R100 ?

    My fork tubes on my '81 are shot with oxidation. (the bike sat 5-6 years before I got it). Got a chance to pick-up the whole fork assembly from a '87 R80, including the triple trees & calipers on the...
  6. Man, you guys know your BBQ & Beemers...thankyou !

    Man, you guys know your BBQ & Beemers...thankyou !
  7. Where are bushings on the fork assembly,'81 r100?

    Went on Maxs' BMW site, located the seals no problem, where are the bushings on the fork assembly/schematic? Are they under a different name ? A part # would really be good...Thanx, al
  8. Replies
    6
    Views
    616

    Where are the bushings in the fork located in the fork schematic??

    Found the seals, where are the bushings located in the fork assembly/schematic ? A part # would be really good ! Thanx again...
  9. Replies
    6
    Views
    616

    Thanks guys...

    Thanks guys...
  10. Replies
    6
    Views
    616

    Fork seals question

    Got a leaking seal on my '81 R100. Obviously both will be replaced. My question is: Is it necessary or maybe just a good idea to replace any bushings in the forks as well? Also, where can I order the...
  11. Replies
    1
    Views
    381

    tail lite problem on RTP1150

    Got a lite problem that's driving me nuts. The taillite on my RTP-1150 stopped working. If you turn the key all the way to the left in the accessory position with the bike parked, it works, so the...
  12. Replies
    6
    Views
    847

    Yes, brown is ground...in my last sentence I...

    Yes, brown is ground...in my last sentence I should have wrote - I tried hooking the original ground wire from the bike to the metal housing of the lite (not original signal).
  13. Replies
    6
    Views
    847

    problem with new LED tail lite

    I bought an LED tail lite for my '81 R100 to replace the old original. I am turning this bike into somewhat of a bobber, with a solo seat. The new lite I have has 2 wires coming out of it, green for...
  14. Replies
    2
    Views
    620

    what's best way to lower a '81 R100 ?

    Just got my '81 fixer-upper on the road...needs ALOT of TLC....Can you just put smaller shocks on in order to lower it, & if so, where can you get them ? Will an 11.5 -inch shock cause the rear...
  15. Replies
    3
    Views
    576

    Thanx guys for the advice, I'll give it a try...

    Thanx guys for the advice, I'll give it a try...
  16. Replies
    3
    Views
    576

    clutch issues on '81 r100

    Just bought an '81 R100 "fixer-upper". The bike had been sitting for 3-4 years. Took the carbs apart, changed fluids, etc. & got it started, motor runs strong. The problem I am having now is it won't...
  17. Replies
    9
    Views
    827

    boy, will you be pissed when I win that BMW...

    boy, will you be pissed when I win that BMW bullet !
  18. Replies
    3
    Views
    676

    Lowering Rt1150

    How can you make an RT1150 lower ?
  19. Replies
    51
    Views
    9,543

    centerstand vs. sidestand

    what is the reason for having a centerstand and a sidestand ? ( sorry for what may be obvious answers to alot of you, my clymer manual is on the way ! ) I was told there is no such thing as a dum...
  20. what are the two LED Lites for between the speedo & Tach on RTP?

    I do not have a book for my just-bought 2004 rtp 1150. I was putting it away, and momentarily could not get it in 1st gear. There are 2 LED's located between the speedo & tach. The right-hand LED lit...
  21. Replies
    0
    Views
    462

    RTP RADIO INSTALL can it be done?

    I just bought a 2004 RTP 1150. Can a stereo/radio be installed where the old police radio was ?- (Im' assuming it was between the speakers ). If so, do the existing speakers have the sound quality...
  22. Thread: engine HP

    by jupiteral
    Replies
    6
    Views
    638

    engine HP

    what is the difference in HP between the RT-RS model motors and the CL models ? Also, what are some other different aspects of the bikes besides the price ?
  23. Thread: engine HP

    by jupiteral
    Replies
    0
    Views
    610

    engine HP

    what is the difference in horsepower between the RT-RS engines and the CL models ? Also, are there any disparities in the wheelbase, etc. ?
Results 1 to 23 of 24