Search:

Type: Posts; User: TZOLK; Keyword(s):

Page 1 of 14 1 2 3 4

Search: Search took 0.06 seconds.

  1. Thread: 1991 r100gs

    by TZOLK
    Replies
    10
    Views
    1,035

    Being an expert in R100GS repair and upkeep, I...

    Being an expert in R100GS repair and upkeep, I will take this off of your hands because you are in for a world of heartache and misery. Trust me:evil Just let me know where to pick it up. Dont trust...
  2. Thread: Multivario

    by TZOLK
    Replies
    2
    Views
    754

    Multivario

    Does anyone know if a R1100GS multivario system will fit the R100GSPD tank? The tanks seem similar in slope.
  3. Thread: Rubber GS

    by TZOLK
    Replies
    26
    Views
    1,883

    So you put longer plastic tubes in the forks. I...

    So you put longer plastic tubes in the forks. I have the exact same set up/ progressive springs, fox rear. You might wany to cut those down so they are overall stock height when compared to the...
  4. Thread: Rubber GS

    by TZOLK
    Replies
    26
    Views
    1,883

    I ride a 90 GSPD and you will notice if you put...

    I ride a 90 GSPD and you will notice if you put pressure on the rearend that the frame torques slightly to the left because of the rear shock set up. Shock is on the right side of the bike, when the...
  5. Thread: GSPD problem

    by TZOLK
    Replies
    1
    Views
    581

    make sure your enrichening circuit on each carb...

    make sure your enrichening circuit on each carb has returned to normal. Sometimes they may not retract all of the way with the spring. Throttle cable freeplay. Maybe a new airleak after the carb....
  6. Replies
    41
    Views
    1,410

    Hey, I was following Him. He was behind me ,thats...

    Hey, I was following Him. He was behind me ,thats all.

    Mark DOES have street cred here in (metro) Detroit.
  7. Replies
    33
    Views
    2,676

    40 mpg is about normal for me also. With the Bing...

    40 mpg is about normal for me also. With the Bing re-jet kit 40 is the tops unless we're crusing at 55mph. Aerodynamics suck and so does the "Over Drive" gear.
  8. Replies
    8
    Views
    5,620

    Omega me

    Have had the Omega on also for 2 years no problems. Rick was helpfull when I bought a Dyna coil from him also. Its nice Quality gear. The Diode board that comes with it is a fine stout piece, Worth...
  9. Replies
    30
    Views
    3,656

    Cool, my first measurements were way off. I think...

    Cool, my first measurements were way off. I think my past gasket useage also would have resulted in bad things but so far so good. Havent torn it apart to measure the con rod big ends or anything...
  10. Replies
    30
    Views
    3,656

    Jim, first of all , you Are a winner in my book....

    Jim, first of all , you Are a winner in my book.
    Secondly, well I took apart the goods again tonight and found out that the canister was about 4mm away. .151" and the oring is .1575 thick. Thats not...
  11. Replies
    30
    Views
    3,656

    So how many miles are we talking to lack of lube...

    So how many miles are we talking to lack of lube damage to the camshafts and rod ends if the o-ring isnt skavished enough. I just finished an oil change. It has the smoothened canister edge on it. I...
  12. Replies
    3
    Views
    840

    Dont forget to plug up that vent at the top of...

    Dont forget to plug up that vent at the top of the seal with some sillycone. Doesnt sound right but it is.
  13. Replies
    1
    Views
    908

    replacement brake caliper

    Does anyone know if another caliper (brand or Diff bike) will fit on an airhead GS late model? Currently looking for a stock one and or other.
  14. Replies
    13
    Views
    759

    Ill bet that one is more "grippy" than the stock...

    Ill bet that one is more "grippy" than the stock rotor. Can get a floating one also. Too Buku for this budget though.
  15. Replies
    13
    Views
    759

    Hey, Try This.................. ...

    Hey, Try This..................

    http://www.spieglerusa.com/cfm/bmwrotors.cfm
  16. Thread: Registration

    by TZOLK
    Replies
    41
    Views
    2,470

    Wow, what a debacle. Here in the big mitten you...

    Wow, what a debacle. Here in the big mitten you just bring the title in and voila! They could care less what you have in the parking lot.
  17. Replies
    2
    Views
    830

    Hey, Mine also acted up. The speed would bounce...

    Hey,
    Mine also acted up. The speed would bounce back and forth about 10mph. I took the black ring off, unscrewed the back and pulled the unit out of the housing. Caution on that black ring, use a...
  18. Replies
    8
    Views
    1,147

    Howdy Rich!!! In that tranny area of my last...

    Howdy Rich!!!

    In that tranny area of my last post I was gonna put, " Just ask BMWRich58 about his Daytona trip"
    Hey, how far did you get on your PD tank while going to alaska and did you ever...
  19. Replies
    8
    Views
    1,147

    Im glad to hear im not the only one with this...

    Im glad to hear im not the only one with this mileage. I average about 39 mpg on the HWY with the Bing "upgraded"jet kit installed.

    As Far as going to Alaska is concerned you certainly dont NEED...
  20. My 90 gspd likes to start with the choke lever...

    My 90 gspd likes to start with the choke lever fully out, clutch lever in, and throttle held open about 1/4 inch . Always starts first thing. Once it starts (running) I back the throttle off. I do...
  21. Replies
    0
    Views
    459

    clunky shifting, improved

    Well, all I did was move the angle of the shift lever pointing more towards the ground, resulting in having to cant my foot more forward, toe more towards the ground. What an improvement in effort,...
  22. Replies
    24
    Views
    4,021

    Oh how I love all this Airhead reveling. I think...

    Oh how I love all this Airhead reveling. I think we should have a giant group hug........... :hug
    Just tuned mine up last night. After 4k the valves didnt even need adjusting. Compression is 145...
  23. Replies
    6
    Views
    856

    That Palo Alto speedo repair joint. It advertised...

    That Palo Alto speedo repair joint. It advertised in the MOA.
  24. Replies
    11
    Views
    1,700

    RideWV, Just want to say thats a pretty nice bike...

    RideWV, Just want to say thats a pretty nice bike you have there!!
  25. Replies
    8
    Views
    713

    The carbs are clean. The left bank idle screw...

    The carbs are clean. The left bank idle screw hole is hogged out a little , it takes fewer turns out to achieve the same idle aspects of the right side. It runs good. Comp is equal. Ill consult my...
Results 1 to 25 of 338
Page 1 of 14 1 2 3 4