Search:

Type: Posts; User: CLAMP007; Keyword(s):

Search: Search took 0.07 seconds.

  1. Replies
    2,762
    Views
    881,948

    Sticky: 1976 r90/6

    Santa Monica, CA
    <a href="http://s95.photobucket.com/albums/l129/clamp007/BMW%20pics/?action=view&current=IMG_0028.jpg" target="_blank"><img...
  2. should I wetsand & polish a freshly sprayed subframe

    I just rattlecanned my subframe & am curious as to whether I should wetsand it with 1500 grit paper or just leave the finished sprayed coat on there. A friend mentioned I should wetsand it & then...
  3. Aftermarket tach for /6......Will any tach work?

    I am in the process of switching out my instruments for something more low profile. I have done the speedo & am in the process of looking for a matching tach. Will any tach work, since there's no...
  4. new tank on /6 with slight rust inside. Can I do the Kreem acid wash only?

    I just bought a new tank with great paint & pinstriping for my R90/6. The inside of the new tank doesn't seem to have any lining at all, not even the red lining. It does have what appears to be...
  5. Replies
    12
    Views
    1,299

    no its a straight bar

    no its a straight bar
  6. Replies
    12
    Views
    1,299

    where can I buy flat drag-type bars for a /5

    Looking for a completely flat bar that would end up being a bit lower than the Euro bar. I've seen some in pictures here & there, but wondering where to buy?
  7. Removing reflector from rear fender on a /6. Is bolt removable?

    I need to remove the reflector, but the nylon threaded nut on inside is just spinning with the bolt inside the reflector. What kind of bolt is in there? Is it built into the reflector or is it a...
  8. Aftermarket speedo on R90/6

    I am finally pulling off the big plastic pod on my 76 /6 & replacing it with a smaller gauge of a 1:1 ratio. It seems that's as close as one can get to the 1.186 ratio that's on there right now. It...
  9. Seems like 20774 was right. The advance unit had...

    Seems like 20774 was right. The advance unit had slipped on the shaft. By finicky, my mechanic had said there was a fine line btw over tightening & under tightening.
    I guess I also need a new...
  10. new dyna installed on R90 & bike died the day after

    Hopefully some help here. I just had some work done on my bike, which included installing a Dyna 3 ignition. Bike was running very smoothly, but not peppy enough. My mechanic advanced the timing a...
  11. Thread: Euro Bars?

    by CLAMP007
    Replies
    28
    Views
    6,572

    Where are most of you buying the Euro bars? I...

    Where are most of you buying the Euro bars? I see that Bobs BMW has a low bar(for R90) & they have a Flanders Europa bar, which is probably 7/8 & a bit tight.
    Is this low bar, the Euro bar? Thanks
  12. Replies
    2,762
    Views
    881,948

    Sticky: 1976 r90/6

    I just bought this bike a month ago. Had been sitting outside & unloved for a year or so, so after much cleaning & polishing, carb cleaning, new rocker arm, valves done, points etc, it is running...
Results 1 to 12 of 12