Search:

Type: Posts; User: Motorwerk; Keyword(s):

Page 1 of 18 1 2 3 4

Search: Search took 0.10 seconds.

  1. Remove the mirror and top trim. Should expose...

    Remove the mirror and top trim. Should expose enough to figure out what to remove/replace.

    Or I can stop by and show you what needs to be removed as I'm not that far from you to the North.
  2. Replies
    51
    Views
    2,909

    and who knew a wrench-turner had such a wild...

    and who knew a wrench-turner had such a wild imagination :)
  3. Replies
    10
    Views
    1,176

    You should be fine with the PR-2 on the rear and...

    You should be fine with the PR-2 on the rear and the PR-3 up front.

    Curious as to whether the replaced rear was a 'B' spec or not.

    As mentioned, 41psi is a bit low from recommended especially,...
  4. Replies
    68
    Views
    5,103

    Paying for a part or having it replaced under...

    Paying for a part or having it replaced under warranty are different circumstances in which the replaced component is made available to the consumer. I don't believe that was conveyed or assumed.
  5. Replies
    68
    Views
    5,103

    There's no 'stretching' of any warranty. The...

    There's no 'stretching' of any warranty. The parts/labor warranty is completely seperate from the orginal warranty. And this is 'industry' has no relevance to another 'industry.'

    Just feel...
  6. Replies
    68
    Views
    5,103

    I think some are missing the point that...

    I think some are missing the point that replacement parts and labor are covered for two years whether or not the failure occurs within the original warranty time period.

    If something were to be...
  7. Replies
    54
    Views
    6,902

    Looking for these -...

    Looking for these - http://www.beemerboneyard.com/r12rtshldarms.html

    http://ep.yimg.com/ca/I/yhst-15102260216258_2221_27205418
  8. Replies
    1
    Views
    728

    The spring is just to keep it from folding up...

    The spring is just to keep it from folding up like the rear pegs. There's no tension until you lift up on it.

    There's is just a C-clip on the shaft - #11 but not really shown in the diagram.
    ...
  9. Replies
    23
    Views
    2,101

    Understood. It sounds like from the OP's...

    Understood. It sounds like from the OP's description that the level from reading it through the sight-glass is correct but continues to display a warning. Best he can do is add more oil and see if it...
  10. Replies
    23
    Views
    2,101

    If the display does not change when you start...

    If the display does not change when you start moving there is definitely something wrong.

    The '05's needed a float replacement and a software update to change this behavior as it would give false...
  11. Replies
    6
    Views
    1,524

    They should be able to test it without removing...

    They should be able to test it without removing the tire with a proximity-type device to see if it's responding.

    When it quits for good the front sensor will stop responding as well.

    That $150...
  12. Replies
    21
    Views
    1,388

    I would try staying off the rear brake. The...

    I would try staying off the rear brake. The additional rear braking force is most likely what caused it to activate the ABS.

    Try this, find a spot with some gravel or similar debris and practice...
  13. Thread: Front Fender

    by Motorwerk
    Replies
    2
    Views
    507

    If you are referring to an RT then, yes -- ...

    If you are referring to an RT then, yes --

    http://www.maxbmwmotorcycles.com/fiche/DiagramsMid/B0004081.png?v=03252011
  14. Replies
    14
    Views
    1,773

    I have the converted turn-signal running lights...

    I have the converted turn-signal running lights on my R1100R. Not legal in Ohio either.

    I'd rather risk a ticket than risk being dead but if a distracted cellphone user does not bother to look up,...
  15. Replies
    6
    Views
    861

    Cee Baileys used to make a Summer shield which I...

    Cee Baileys used to make a Summer shield which I have and use during the warmer months. Looks like it was replaced with a sport shield.
  16. Replies
    3
    Views
    635

    How long has been since reset? I generally...

    How long has been since reset?

    I generally don't trust it but reset it at every gas stop and it does vary although, not much.
  17. Replies
    9
    Views
    813

    Pull the filter and drain that - no need to pull...

    Pull the filter and drain that - no need to pull the drain plug.

    I wouldn't worry about it though. Not sure what the later models recommend but boxers typically are checked cold - after a full...
  18. Replies
    11
    Views
    843

    With less than 10k I wouldn't worry about it. It...

    With less than 10k I wouldn't worry about it. It should have been changed at the initial 600mi run-in though - might want to check on that. The current recommended change interval is 12K.

    Be sure...
  19. Replies
    64
    Views
    3,712

    It's true there is a battery in the TPM sensor...

    It's true there is a battery in the TPM sensor but as mentioned is not serviceable (that I know of).

    When the sensor is replaced the bike is connected to the GT1 (BMW service uber computer) and...
  20. Replies
    64
    Views
    3,712

    It could be the sensor is starting to fail. ...

    It could be the sensor is starting to fail.

    The rear sensor on my '07 started this way until it finally quit several months later. The front sensor would then stop responding after about a 1/2-1...
  21. Just replaced mine with Hyperpros this past...

    Just replaced mine with Hyperpros this past Spring. Great improvement especially when fully loaded.

    They sometimes need to be reset at the dealer from losing their position as mine did.
  22. Replies
    4
    Views
    1,098

    You might be better off shipping them to Klaus to...

    You might be better off shipping them to Klaus to transfer the ESA components which what I did. Although, I did retain the stock height.

    I have no idea how it was done but it may need to be reset...
  23. Replies
    22
    Views
    2,076

    Neat! Wonder why it's not included with US bikes....

    Neat! Wonder why it's not included with US bikes. You guys normally get heated mirrors standard on cars too. :(
  24. Replies
    22
    Views
    2,076

    There is no indicator for the heated grips on the...

    There is no indicator for the heated grips on the RID only the heated seat so don't expect to see anything. Sounds like it's functional.

    Even if you had the software the GS-911 is not capable of...
  25. Replies
    8
    Views
    1,644

    Wilburs, Ohlins, Racetech, Hyperpro, Works and...

    Wilburs, Ohlins, Racetech, Hyperpro, Works and others can offer aftermarket shock replacements. Having ESA and wanting to keep that function limits your choices and timing.

    It's not very difficult...
Results 1 to 25 of 435
Page 1 of 18 1 2 3 4