Search:

Type: Posts; User: BRUCETONER; Keyword(s):

Search: Search took 0.06 seconds.

  1. Replies
    11
    Views
    807

    I to had the awful clanking on startup. Replaced...

    I to had the awful clanking on startup. Replaced the left side cam chain tensioner with the upgraded tensioner from BMW and wow! What a difference! Starts are completely rattle free. Not sure if...
  2. Replies
    26
    Views
    2,426

    Thanks Mike, Cheers! Bruce:ca

    Thanks Mike,

    Cheers!

    Bruce:ca
  3. Replies
    26
    Views
    2,426

    Mike, What voltage were you getting at the...

    Mike,
    What voltage were you getting at the starter with the bad starter? Did you happen to recheck it with the new one? I am wondering what the voltage would be if the starter is ok.


    Bruce
  4. Replies
    11
    Views
    927

    Good point. Doesn't say much for BMW earlier...

    Good point. Doesn't say much for BMW earlier machining and balancing capabilities! When the bike was fully assembled was it vibration free at 3-4k rmp?
  5. Replies
    11
    Views
    927

    why are they not marking them? Did you get an...

    why are they not marking them? Did you get an explanation? Are they perfectly balanaced then? Hummm....
  6. Replies
    11
    Views
    927

    I just went through exactly the same process as...

    I just went through exactly the same process as you did and Paul's explanation is right on the money. There were some other confusing paint marks on my parts. There were small different colour dots...
  7. Replies
    19
    Views
    1,191

    You know it! Will probably use an early clutch...

    You know it! Will probably use an early clutch spline lube as an excuse to go in and gitit!


    Cheers!

    Bruce:ca
  8. Replies
    19
    Views
    1,191

    Well... thanks everyone for putting in the...

    Well... thanks everyone for putting in the effort. MotorradMike first suggest top transmission bolts. I knew I had six in there and torqued correctly. One of the issues with a repair like this...
  9. Replies
    19
    Views
    1,191

    Hey Gary thanks I will try that. I have been...

    Hey Gary thanks I will try that. I have been looking through the service manual I have but they don't do a very good job of showing all of the fasteners in the exploded views. Mike... thank you as...
  10. Replies
    19
    Views
    1,191

    I have to say I was chuckling reading the above...

    I have to say I was chuckling reading the above posts. Lighter... yes, did I by mistakingly leave out one of those unnecessary fasteners... perhaps. But as PAS says... I will not sleep until I...
  11. Replies
    19
    Views
    1,191

    One left over bolt

    I recently did a clutch and slave cylinder replacement on a 2002 R1150RT. I read as much as I could beforehand on what could be the issues with my slipping clutch. As it turned out the transmission...
Results 1 to 11 of 19