PDA

View Full Version : cyl head re-torque



MechanicSavant
10-02-2007, 06:41 AM
does any one know if the cyl head re-torque @ 600 mi. is the same as on an 1150 .. 15ft/lbs then 90deg + 90deg and 30ft/lbs on the8mm bolt ???

The_Veg
10-02-2007, 04:51 PM
This may help:

Torque Table (http://www.r1200gs.info/misc/torque.html)

MechanicSavant
10-03-2007, 06:58 AM
Just what I needed , Thanx

jimvonbaden
10-04-2007, 07:24 PM
http://i20.photobucket.com/albums/b238/JimVonBaden2000/Service%20Video/headboltsmarked.jpg
These are 20nm if you have to loosen them, try to find THEM in the manual or torque chart. I had a heck of a time.:banghead

The head bolts for retorque are 20nm plus 180 degrees.

The T-45 Torx is 40nm

This is slightly different than the initial torque of a new head gasket.

Jim :brow