HID Low Beam Install on R1200RT

[swilson143]

I finally finished my HID low beam install today. Came out great! I bought my HID kits from http://www.cqlight.ca/ I’ve purchased from them 3 times now and many friends have bought their kits as well… good company.

Most of what you see in this photo I completed a couple weeks ago. I created an aluminum bracket to hold the Centech fuse block in place using a couple of existing screws. The bracket also holds two 70A relays. One powers the fuse block when the key is on. The other was dedicated to the HID low beams.

13234

[swilson143]

My bike doesn’t have the speakers, so I had a ton of room behind the dash to mount the HID ballasts. I mounted them opposite each other on the mirror supports.

13235

[swilson143]

13236

[swilson143]

I cut a piece of aluminum and drilled holes though it help my mount the ballast. It sandwiches part of the mirror support and holds the ballast rigidly in place with no holes drilled into my bike. For info… if you buy your kit from CQLight I can tell you screws needed to fit the pre-threaded holes in the ballast housing are M4 0.7 pitch. I used 4 of them.

13237

[swilson143]

13238

[swilson143]

From researching on the web I knew many people are getting Bulb Error warnings on their dash when installing HID kits because CANBUS is looking for the correct resistance from the filament in the light bulb to know that the bulb isn’t burnt out… since the HID kits don’t have the correct resistance (I have heard certain kits have been designed to now have the correct resistance, but don’t know who might be selling them) CANBUS thinks the bulb has burnt out and displays an error.

Some people have fooled CANBUS by adding resistors to their wiring setups. I went another route. I used my factory low beam wiring to power a set of PIAA 004XT lights I added under the oil cooler. Since CANBUS sees a bulb at the end of the wiring you get no errors! Here is a wiring diagram of what I did. The rating on the relay is so high because I used it to power both HID low beams.

13239

[swilson143]

Here is the finished product. Sure makes those side marker lights look yellow… is there an LED replacement that doesn’t cause CANBUS errors?

13240

[swilson143]

While I was in there mucking around I installed some Hyperlites. They rock. I just wish someone would also come out with an LED bulb replacement for the stock brake light housing that is CANBUS compatible.

13241

[Easy]

Well Done!!!

Easy :usa