Abs....oops???

[docsouce]

When putting the front wheel back on my '02 R1100SA, I apparently pushed the brake pads to far back. This because I saw some brake fluid dripping out of what looks like a rubber overflow or breather tube that comes down from under the gas tank.......Because of all the snow and Ice I haven't had a chance to road test the bike or if I do will I do road test will I damage ABS... Any ideas how badly I screwed up.

[JimVonBaden1]

It wont hurt the ABS, but it will the paint if you got brake fluid on it.

Otherwise, just make sure your level is good when you pre-ride check the bike and you should be fine.

Jim :brow

[docsouce]

Thanks Jim. I was trying to.... Well, I was being lazy. I should have just lowered the fluid in the master cylinder like I usually do..Again thanks