PDA

View Full Version : Fuse box parts need a part number

Djstephens
10-15-2006, 06:06 AM
Hi Everybody,
I'm looking for a part number to order some additional fuse terminals, but was unable to locate it on a parts fiche. I am in particular I am looking for one that will allow me to share the power in, with one wire block and have the other side of the fuse separate. I hate trying to relay what I want over the phone with the a dealer and hope to get the right part. I looked for the item on the microfiche that A&S has on their web site, but it didn’t go into enough detail on the fuse box area. Currently I have these new wires just soldered to the old terminals and several jumper wires for the supply. It looks fine from up top, but I would like to do it right with new parts.

Any advice would be greatly appreciated.
Thanks in advance,
Dashpush
Djstephens
10-15-2006, 06:10 AM
This in the main item that I need, but would also like the ones that come as a string of five terminals already connected. This way I only need one hot wire in. :D
cjack
10-15-2006, 07:48 AM
This in the main item that I need, but would also like the ones that come as a string of five terminals already connected. This way I only need one hot wire in. :D

Those fuse terminals are available from BMW. They are not in the parts fiche. I will remember to check the part # next Tue when the shop opens (they are in stock there) and post another reply. They are not available in a preconnected string that I am aware of.

I just looked at the ones I have and they seem a bit different. Your picture is a little blurry. Mine are smooth on the sides and yours seem to have something on the narrow sides. Mine have a barb on the long side that hold the clip in. Is the one you are holding the same?
Djstephens
10-15-2006, 10:47 PM
I would be glad to purchase it from your palce of business if you'll PM me the number.
Thanks,
DJ
:wave
cjack
10-17-2006, 02:57 PM
I would be glad to purchase it from your palce of business if you'll PM me the number.
Thanks,
DJ
:wave

The part number I have for fuse clip inserts is 81 24 9 408 099. They come in a pack of 100. They look a little different from your picture, so I don't know if they will fit in your fuse blocks. I'll send you some gratis if you want to try them. Email me with an address.
Jack
Djstephens
10-25-2006, 07:49 PM
Thank you so much they are just what I needed.