Activity Stream

I have posted on this bike before. My new to me R1100R starts fine, runs a minute to 4 minutes then cr@ps out, by that I mean it goes into a mode...

After reading the WBW review I decided to order. I went to Kaoko's site and had to select "not listed" . I got a pretty quick response from them...

Any ideas where I can find a R100/7 engine badge ? Looks kinda bad without it. Thanks for any leads!

morning all, my brake light is stuck on, I guess that means one of the switches is defective, I can see the switch on the back, not sure how it works...

I have two K bikes- an 88 K100RS, and an 02 K1200 RS. Both have similar mileage- just over 50K. Last year, My K100 was found to have worn out...

Torqued down to hard on the lower left valve cover screw on my 2007 RT. Does anybody know the fix? And can I ride it anyway? It doesn't seem to be...

Hi all, about two months ago I traded my K1200LT for my latest/greatest ride. A 2008 R1200RT. I really liked the LT and rode it for the last four...

Paging thru my July 2013 issue of MOTORCYCLIST last night, I noticed the 'spy' photos of the 2014 R1200RT undergoing final road testing in southern...

All right you S fans. Check out the concept bike BMW has on their website. More photos and write-up here:...

Hey all, So once again still finding little joys of problems with my /5. Mechanically everything was running great until yesterday morning. As I...

Getting my old /7 ready to roll again and noticed during the carb disassembly that my carbs do not have the springs in the diaphram area. Is this...

I have tried to use a Gerbing MP (the newer microprocessor one - serial number ends in MP) single controller for a Gerbing jacket liner on my R90/6....

I was thinking of posting my low R1200RT for sale, but there are so many listed. Is this the place to sell them? They also seem high priced. Does...

Does anyone have experience putting a /7 seat on a /6 bike (small tank)? I understand there is a gap of abut an inch between the seat and the tank. I...

Leaving Charleston, SC Aug 1st to Inuvik and then Prudoe Bay. Anybody done this trip in August? Used to live in Southeast AK but not to familiar...

I'm trying to find an independent repair shop who did work for me in the past but the number I had for him has been disconnected. I was wondering if...

Googled and tapatalk not working right . What is your favorite backpad for Darien . Had Roadcrafter with 'stitch backpad . Looking for something...

Hi, I am looking for a bike to work on and ride - not a full blown restoration, just enough to be clean, reliable and wrench able. My skills are...

While I had the Tupperware off today, I got to thinking about the stock speakers and if louder aftermarket speakers were available. So, I figured...